Flstsc exhaust question
Thread Starter
|
Tourer
Joined: May 2011
Posts: 401
Likes: 0
From: Sydney, Australia
Flstsc exhaust question
I know I'm gonna be called stupid for asking this question, but the exhaust for a flstsc (Softail Springer Classic) is on left and right sides of the bike. If I get an aftermarket exhaust will I be left with an ugly looking gap where the exhaust goes under the seat, behind rear exhaust. And will there be exhaust brackets or anything ugly on the frame from where the left exhaust was?
Road Warrior
Joined: May 2009
Posts: 1,493
Likes: 94
From: Belgium
Won't be that ugly once that exhaust pipe is gone. All engines and frames are basically the same. Wouldn't say that bikes with different exhaust layout have an ugly hole at the rear cylinder.
All the brackets for mounting the left part of the exhaust will come off. You can get some black plugs to cover up the bolt holes or just put the bolts back in and paint them black.
All the brackets for mounting the left part of the exhaust will come off. You can get some black plugs to cover up the bolt holes or just put the bolts back in and paint them black.
Stellar HDF Member
Joined: Oct 2009
Posts: 2,054
Likes: 26
From: Florida
Like Rakthi says, if you take everything off then it will look no different than any other similar year softail that has a right-side-only exhaust. Harley doesn't design their bikes around the exhaust system so once you take it off, there should be nothing left to indicate what sort of pipes it had from the factory. Also, after market (as well as other types of OEM Harley pipes) are designed to use the same mounting points as the stock pipes do on a particular model of softail. So if you are going with a right-side-only exhaust, most of the holes left on your frame from removing the stock pipes might get re-used with the installation of the new set-up. Anything else can be plugged up with plastic plugs or some nice button head bolts.
Thread
Thread Starter
Forum
Replies
Last Post
