I want to swap the C and D wires from the wiring to the coil so I can turn the plug wires facing downward when I relocate my coil. Can someone tell me which of the 4 wires are the C and D so I can swap the front and rear plug wires?

 

should be stamped on the wire side of the connector plug

 

 

+1, they are stamped on the plastic connector, but that wiring diagram is a lot easier to read!

 

Thanks guys. I finally found it after the first post. It's on the Delphi connector but if you don't know to look for it you would never see it.

Another note, I'm a dumba$$. I thought 8" would be enough wire extension for the coil but after I finished soldering everything it ended up about 3" too short. Now I got to redo it all. What a pain in the @$$. I'm a dummy.

 

Where are you putting it? I didnt need to extend my wires.

 

That looks familiar...

 

Dupe deleted

 

Running the coil wires up the spine and moving it where the horn was. I tried to squeeze some extra length out but its not even close.

 

haha..yeah..oddly familiar..


and I had to extend my wires by 10-11" each..sucks to do it twice :'(