Does anyone know a good company to deal with that can make wheels from a drawing or picture?

 

I'm sure just about any manufacturer would be willing to do it as long as your pockets are very deep. A lot of work is involved in a one off set of wheels. Although programs nowadays allow easy tool path programing and G-code.

 

thanks, was just checking to see if there was a smaller company that did good work. Rumble Customs (no longer in business) made a wheel with Foose back in 2002 that I have wanted ever since i saw it, but now my only option is custom made.

 

Seen these guys on eBay quite a bit. They take H-D solids and custom cut them. Might be worth looking into:
http://stores.ebay.com/IMPRESS-PLATI...p2047675.l2563

 

A few years back I was looking to match a pulley/rotor from PM to a set of wheels made by someone else. They had no trouble doing it then. You might try asking them if they could help you. In my experience thier customer service is amazing.

714-523-3000