anyone have stock bars from fatboy lo
Thread Starter
|
Tourer
Joined: Feb 2014
Posts: 491
Likes: 10
From: ATX
anyone have stock bars from fatboy lo
i'm putting apes on mine, actually i'm making apes for mine because no one sells what i'm looking for. anyways, i'm making 1-1/4" bars, but before i start the build, what do they step down to where the grips go? are both sides a 1" step down? i ask because the grips i bought for my bike one side is 1" ID the other is 1-1/8" ID (which i'm assuming is so it fits over the throttle). just want to make sure (and honestly i'm too lazy to pull stuff off to check if i can just sit here in my underwear and ask someone else who has done it before 
)
)
Club Member
Joined: Jan 2007
Posts: 3,561
Likes: 1,938
From: NE Florida
i'm putting apes on mine, actually i'm making apes for mine because no one sells what i'm looking for. anyways, i'm making 1-1/4" bars, but before i start the build, what do they step down to where the grips go? are both sides a 1" step down? i ask because the grips i bought for my bike one side is 1" ID the other is 1-1/8" ID (which i'm assuming is so it fits over the throttle). just want to make sure (and honestly i'm too lazy to pull stuff off to check if i can just sit here in my underwear and ask someone else who has done it before )
)
Thread
Thread Starter
Forum
Replies
Last Post
