Braided stainless cables & lines
Thread Starter
|
Ultimate HDF Member
Joined: May 2008
Posts: 7,439
Likes: 884
From: 'Noke, VA
Braided stainless cables & lines
I'm nearly positive these are Magnum Chromite. If they're not, they're the same vinyl-sheathed cables that they sell. All of them came off of my bike, and were only on for about 7,000 miles. I have no idea how they compare to stock length, but they're nice and in good shape. I measured to the ends of the fittings, but by no means are these exact measurements.
The throttle & idle cables are 34".
Rear brake line is 20" from the switch manifold to the caliper fitting (which should be stock), 32-1/2" from the switch manifold to the master cylinder fitting....This was set up for 3" extensions on my bike.
Front brake line is 45-1/4".
Clutch cable is 61-1/2" overall, I know it's the stock measurement from the transmission to the adjuster.
For reference, they came off a 2005 Night Train with H-D Street Slammer bars and inverted forks (and the aforementioned 3" Ness extensions). The whole kit & caboodle was somewhere north of $400, take it all for $150+shipping.
The throttle & idle cables are 34".
Rear brake line is 20" from the switch manifold to the caliper fitting (which should be stock), 32-1/2" from the switch manifold to the master cylinder fitting....This was set up for 3" extensions on my bike.
Front brake line is 45-1/4".
Clutch cable is 61-1/2" overall, I know it's the stock measurement from the transmission to the adjuster.
For reference, they came off a 2005 Night Train with H-D Street Slammer bars and inverted forks (and the aforementioned 3" Ness extensions). The whole kit & caboodle was somewhere north of $400, take it all for $150+shipping.
Thread
Thread Starter
Forum
Replies
Last Post
DR. V-TWIN
General Harley Davidson Chat
6
Jun 5, 2010 04:52 PM
