VSS signal
Thread Starter
|
Stage I
Joined: Jun 2016
Posts: 1
Likes: 0
From: Austin, TX
VSS signal
Hello all, I have an accessory (strobe wise) that needs the VSS signal. I think I have found the sensor (3 wires on the top of the transmission, but not where I can tie into the signal. Bought the service manual for the bike, but no help there.
I have a 2013 Harley 1200 Custom, 110 Limited. Anyone have a clue where to pick up this wire?
Thanks in advance!
Rob
I have a 2013 Harley 1200 Custom, 110 Limited. Anyone have a clue where to pick up this wire?
Thanks in advance!
Rob
Stellar HDF Member
Joined: Sep 2013
Posts: 3,492
Likes: 610
From: USA
According to the part finder, the same VSS has been used since 2005 - #74402-05B.
Now looking at the 2008 Sportster Electrical Diagnostic Manual, the 3 wires are as follows:
A - BK/R - 5 Volt Sensor Power (terminal 14 ECM)
B - BK/BE - Vehicle Speed Sensor Input (terminal 33 ECM)
C - BK - Ground
Now looking at the 2008 Sportster Electrical Diagnostic Manual, the 3 wires are as follows:
A - BK/R - 5 Volt Sensor Power (terminal 14 ECM)
B - BK/BE - Vehicle Speed Sensor Input (terminal 33 ECM)
C - BK - Ground
Thread
Thread Starter
Forum
Replies
Last Post
Gnassty
Ignition/Tuner/ECM/Fuel Injection
5
Aug 28, 2023 09:49 PM
