P code 562
Thread Starter
|
Road Warrior
Joined: Aug 2009
Posts: 1,287
Likes: 592
From: USA
P code 562
So I'm out this weekend and just before I leave to head home I start my bike and notice the check engine and battery light come on. After a few seconds it went off. So I ride home and all runs good. So I check the codes and I get p562 which is low battery voltage. The battery is one year old and on tender all winter. It turns the engine strong. So possibly voltagage regulator? Just a fluke? The check engine light still will come on for a few seconds but the battery light doesn't.
Seasoned HDF Member
Joined: Feb 2007
Posts: 5,067
Likes: 394
From: Edmonton Alberta Canada
I'd remove the battery ground at the motor, clean both surfaces and put dielectric grease on it and reconnect, don't just look at it, this is a common problem spot.
Also the 2006/2007's are prone to corrosion in the fuse box including the two black square relays that can cause all sorts of problems, a good inspection/cleaning there may be needed too.
Also the 2006/2007's are prone to corrosion in the fuse box including the two black square relays that can cause all sorts of problems, a good inspection/cleaning there may be needed too.
Thread
Thread Starter
Forum
Replies
Last Post
8upguitarman
Primary/Transmission/Driveline/Clutch
9
Dec 21, 2012 10:26 AM
