Sissy bars
Thread Starter
|
Outstanding HDF Member
Joined: Aug 2009
Posts: 2,272
Likes: 20
From: Shamokin, PA
The one in your sig? Maybe a little too tall for me but how many inches is it so I know what to look for.
Road Master
Joined: Sep 2010
Posts: 1,056
Likes: 0
From: Cottage Grove MN
I made mine 25" from the tip to the top of the fender.
Road Master
Joined: Sep 2011
Posts: 764
Likes: 1
From: N. Texas
I have the same as Aaron. FINALLY got it installed today! I dig it. Due to me F'n up 1 of the holes I had to cut mine 1.5" shorter.
Trending Topics
Here's a couple of pics.
Don't remember how tall the square stock one is...was a one-off we did for a customer.
The round stock bar is attached to the HD mount plates and is 32" tall. The dagger edges have been dulled and it is attached to the bar with 3 screws.
Don't remember how tall the square stock one is...was a one-off we did for a customer.
The round stock bar is attached to the HD mount plates and is 32" tall. The dagger edges have been dulled and it is attached to the bar with 3 screws.
Road Master
Joined: Jul 2010
Posts: 1,051
Likes: 7
The one in my sig pic is 31". Mine was done a little differently. I bought the side plates and a stock 18" sissy bar from cyclevisions. I did not like how upright the sissy bar sat with the stock side plates, so I took it to a local customizer, he cut it up, put it at the angle I wanted, and extended it to 31".
Elite HDF Member
Joined: Nov 2005
Posts: 3,654
Likes: 362
From: Mansfield Texas
Thread
Thread Starter
Forum
Replies
Last Post
