Rev tech DFO
Thread Starter
|
Tourer
Joined: Aug 2006
Posts: 480
Likes: 1
Rev tech DFO
I bought a rev tech dfo for the 06 ultra because it runs so lean, I started the install tonight and it says unbolt the the gas tank and prop it up so you can run the wires and get at the connectors, I don't think so. I ended up removing the gas tank completely in order to be able to run the wires. Anyone end up doing this also or did I miss something?
Thread Starter
|
Tourer
Joined: Aug 2006
Posts: 480
Likes: 1
RE: Rev tech DFO
How did you run the wires?
ORIGINAL: xxxflhrci
I unbolt the front and the back. I lift the front and then shift the tank a bit to the left. I make the wire connections with a set of pistol grip needlenose pliers.
I unbolt the front and the back. I lift the front and then shift the tank a bit to the left. I make the wire connections with a set of pistol grip needlenose pliers.
Road Warrior
Joined: Feb 2006
Posts: 1,281
Likes: 8
From:
RE: Rev tech DFO
Run the wires in the plastic loom that goes up the backbone. If you can't get them in there you can run them next to it and cable tie them to it. Just make sure the tank doesn't sit on them.
Thread
Thread Starter
Forum
Replies
Last Post
