Can anyone identify this part
Thread Starter
|
Road Master
Joined: Oct 2009
Posts: 861
Likes: 136
From: Wisconsin
Can anyone identify this part
I found this piece on the garage floor and can't figure out where it can from. It's about 1/4 diameter and a little over a 1/4 long. it's tapered somewhat on the end and has a hole resest in the end, looks like a hollow tipped bullet. it's been torn off from somewhere under the bike, because you can see, opposite end of the hollow tip has been rip off, maybe from the lift. It came off of a 2014 FLTK
Thanks Jonnierock
Thanks Jonnierock
Thread Starter
|
Road Master
Joined: Oct 2009
Posts: 861
Likes: 136
From: Wisconsin
No. I don't know when or where it came off. I just put it on the lift and then lower it, and a little later I found it on the floor. I don't even know, it might of been there before I started.
Seasoned HDF Member
Joined: Jan 2011
Posts: 157,525
Likes: 57,081
From: Michigan 15 Minutes East Of Hell
Thread Starter
|
Road Master
Joined: Oct 2009
Posts: 861
Likes: 136
From: Wisconsin
BINGO ! Uncle Larry. After my last post I went out and look everything over again and found that the rubber pads on the lift are secured with little rubber nubins that squeese though holes in the lift to hold the pads on. when I got back, I seen your response. You where dead on.
Thanks Jonnierock
Thanks Jonnierock
Thread
Thread Starter
Forum
Replies
Last Post
