Horny Problem
Ultimate HDF Member
Joined: Feb 2009
Posts: 5,132
Likes: 228
From: Garland, TX
Thread Starter
|
Road Master
Joined: Jun 2015
Posts: 800
Likes: 39
From: Lafayette, La
Easier said than done
I bought a relay kit. I have no idea how to connect it. I know one red wire connects to the positive on the battery. But the relays show connection to the compressor of the horn. My Minibeast is not an air horn. It has no separate compressor.
So where in the name of CANbus do I run the wires. I have the 2015 Ultra service manual and they don't show where the horn wires are located or if they do, I can't find it.
Thanks again.
So where in the name of CANbus do I run the wires. I have the 2015 Ultra service manual and they don't show where the horn wires are located or if they do, I can't find it.
Thanks again.
Cruiser
Joined: Dec 2012
Posts: 208
Likes: 6
From: Renton, WA
Check your main horn assembly. My newest one has the relay attached to the overall assembly which mounts on the old horn mount. Without this relay, you would be blowing fuses as the horn draws quite a bit of current.
Thread Starter
|
Road Master
Joined: Jun 2015
Posts: 800
Likes: 39
From: Lafayette, La
I watched the video. "Follow the wires of the stock horn." I followed what I could, but it felt like they went under and forward. Suffice to say, the route was different from on the video.
I like Onramps thought - that there is a relay attached to the overall assembly. Although I don't see that on mine, it might be an easier install. To the dealer I'll go tomorrow I guess.
I like Onramps thought - that there is a relay attached to the overall assembly. Although I don't see that on mine, it might be an easier install. To the dealer I'll go tomorrow I guess.
Last edited by cajunlowrider; Jan 29, 2016 at 10:07 PM. Reason: Clarify my post
Thread
Thread Starter
Forum
Replies
Last Post
Oldtigercub
Touring Models
0
Aug 25, 2010 11:38 PM
