Breather Catch Can Clamp Needed
Thread Starter
|
Supporter
Joined: Mar 2008
Posts: 4,419
Likes: 90
From: Vermont
Breather Catch Can Clamp Needed
I purchased a DK small breather catch can but would like to mount it with a clamp that goes around the can itself and can attach to any of the frame members or some bolt access point. Anyone have any ideas on where to find such an animal? The current design is to just tie wrap it which I don't want to do. Thanks for site recommendations or pics etc?
Thread Starter
|
Supporter
Joined: Mar 2008
Posts: 4,419
Likes: 90
From: Vermont
That shape clamp is along the idea Im looking for. Im hoping to find a stainless or painted rubber lined version. Thanks for the idea though...Appreciated
Grand HDF Member
Joined: Jun 2010
Posts: 4,584
Likes: 918
From: coast to coast
I was interested in the same thing, but didn't find it yet. In the meantime I have mine zip tied down near the engine guard. It is secure and out of the way.
This photo makes it look like it hangs low, but it is higher than the support frame so no danger of contacting the ground in a lean.
This photo makes it look like it hangs low, but it is higher than the support frame so no danger of contacting the ground in a lean.
Last edited by Thingfish; Jun 14, 2016 at 01:14 AM.
Thread Starter
|
Supporter
Joined: Mar 2008
Posts: 4,419
Likes: 90
From: Vermont
I was interested in the same thing, but didn't find it yet. In the meantime I have mine zip tied down near the engine guard. It is secure and out of the way.
This photo makes it look like it hangs low, but it is higher than the support frame so no danger of contacting the ground in a lean.
This photo makes it look like it hangs low, but it is higher than the support frame so no danger of contacting the ground in a lean.
Thanks I appreciate it
Road Master
Joined: Feb 2007
Posts: 781
Likes: 35
From: St Louis
Thread Starter
|
Supporter
Joined: Mar 2008
Posts: 4,419
Likes: 90
From: Vermont
Thread
Thread Starter
Forum
Replies
Last Post
