Smart Siren II - Pager programming
Thread Starter
|
Tourer
Joined: Apr 2007
Posts: 253
Likes: 4
From: Central Indiana
Smart Siren II - Pager programming
We bought the wife a new FXDC with the factory security system. I installed the smart siren II. I have the pager and it is programmed for my ride. The pager should handle both bikes but I have lost the programming instructions for the pager. I forgot how to get it into the "teach" mode. Anyone still have their pager instruction sheet?
Tourer
Joined: Jun 2006
Posts: 452
Likes: 1
From: Virginia
RE: Smart Siren II - Pager programming
1. Ensure pager receiver is turned OFF.
2. Press and hold the pager receiver button (D). The pager receiver will flash and vibrate to indicate it is in the ON mode. Continue to hold the button until the LED indicators begin to flash one after another and the receiver begins to beep once every two seconds. The pager receiver is now in the encoding mode.
Note: The encoding mode will time out after beeping five times. It it times out repeat Steps 1 and 2.
3. Press the Security System Key Fob once to arm the security system. The pager receiver will indicate that it has been successfully encoded by beeping four times.
2. Press and hold the pager receiver button (D). The pager receiver will flash and vibrate to indicate it is in the ON mode. Continue to hold the button until the LED indicators begin to flash one after another and the receiver begins to beep once every two seconds. The pager receiver is now in the encoding mode.
Note: The encoding mode will time out after beeping five times. It it times out repeat Steps 1 and 2.
3. Press the Security System Key Fob once to arm the security system. The pager receiver will indicate that it has been successfully encoded by beeping four times.
Thread
Thread Starter
Forum
Replies
Last Post
davidson, encoding, harley, hd, ii, instructions, manual, pager, programing, programming, security, siren, smart, smartsirenii, system
