Wiring problem?
Thread Starter
|
Intermediate
Joined: Oct 2019
Posts: 38
Likes: 7
From: Minnesota
Wiring problem?
So I recently put new bars on my 2011 HD street glide. Got it all back together earlier tonight, started it up, checked all my switches, Nice! everything works like it should... until I give it a rev and nothing. Where would you check first? Thanks Again!!!
Grand HDF Member
Joined: Jun 2009
Posts: 4,006
Likes: 1,240
From: On the Front Range, CO
Are you sure you reconnected the twist grip sensor? Its a separate 6 pin plug.
Else, the nonCVO bikes have an infamous green clip in line on the twist grip sensor wiring. They are known for breaking or coming apart while the wires are being ran thru the bars. Many either remove/solder those connections or replace the TGS with a CVO version which has no green clip.
Else, the nonCVO bikes have an infamous green clip in line on the twist grip sensor wiring. They are known for breaking or coming apart while the wires are being ran thru the bars. Many either remove/solder those connections or replace the TGS with a CVO version which has no green clip.
Grand HDF Member
Joined: Jun 2009
Posts: 4,006
Likes: 1,240
From: On the Front Range, CO
The green 6 pin is the inline green clip that is on the nonCVO bikes fro your 2011.
The TGS harness that actually connects into the main bike harness should be tan if memory serves me correctly.
The TGS harness that actually connects into the main bike harness should be tan if memory serves me correctly.
Thread
Thread Starter
Forum
Replies
Last Post
