Engine Install / Alignment
Thread Starter
|
Road Master
Joined: Dec 2006
Posts: 1,200
Likes: 3
From: Simpsonville, SC
Engine Install / Alignment
Whats the deal with installing and aligning a rubber mounted engine in an FLHT frame? I'm redoing an 03 FLH theft recovery bike that didn't have an engine, I got an 06 Ultra motor for it and dropped it in, what has to be done to align it properly? It has the original heim joint, I'm not sure if that's OK or if it needs to be aligned and exactly how to do it.
Ultimate HDF Member
Joined: Feb 2006
Posts: 5,939
Likes: 3
From: TX
There is an alignment jig that is used to "square up" the engine in the frame. The tunrbuckles are used to hold in place, once aligned with the jig.
http://www.georges-garage.com/chassis_tools.htm
Look for p/n 740050
http://www.georges-garage.com/chassis_tools.htm
Look for p/n 740050
Road Master
Joined: Jan 2006
Posts: 1,221
Likes: 40
From: Chester NY
There is an alignment jig that is used to "square up" the engine in the frame. The tunrbuckles are used to hold in place, once aligned with the jig.
http://www.georges-garage.com/chassis_tools.htm
Look for p/n 740050
http://www.georges-garage.com/chassis_tools.htm
Look for p/n 740050
Thread
Thread Starter
Forum
Replies
Last Post
