FLHP ABS Indicator Light
Thread Starter
|
Advanced
Joined: Feb 2008
Posts: 56
Likes: 0
FLHP ABS Indicator Light
My 07 FLHP did not have a tach when I bought it so I scored one on eBay. I installed it yesterday and it works sweet with the exception of the ABS indicator staying lit continuously. I assume that the smaller of the two connectors is supposed to go to the ABS controller but my bike does not have ABS. Any suggestions in how to lose the light without opening up the tach?
Road Captain
Joined: Oct 2007
Posts: 602
Likes: 2
From: Lakewood, N.J.
My 07 FLHP did not have a tach when I bought it so I scored one on eBay. I installed it yesterday and it works sweet with the exception of the ABS indicator staying lit continuously. I assume that the smaller of the two connectors is supposed to go to the ABS controller but my bike does not have ABS. Any suggestions in how to lose the light without opening up the tach?
You may have to feed a signal to it. I don't know the logic behind it but you'll have to research it.
Last edited by RoadKing_Al; Jan 11, 2009 at 01:40 PM.
Outstanding HDF Member
Joined: Jul 2007
Posts: 2,847
Likes: 0
From: Missouri
When you have ABS the light will come on till you reach 10mph [I think that's the speed close anyway] It then checks to see if there working and if everything is ok it goes out. You need to find the wire to that light and unhook it.
Thread
Thread Starter
Forum
Replies
Last Post
