Running Wires inside Stock Bars
Running Wires inside Stock Bars
Seasoned HDF Member
Joined: Jun 2006
Posts: 28,559
Likes: 3,954
From: Vermont
Yes folks have done it. Biggest tip to offer is to buy the 55918-08 $35.95 top clamp that comes stock on all the 08 and later fairing bikes. It is one piece and will give you the stability so it doesn't break where you drill it. Also put 56298-03 $39.95 polyurethane riser bushings in while there.
Last edited by dawg; Jan 7, 2010 at 12:26 PM.
Road Warrior
Joined: Sep 2008
Posts: 1,549
Likes: 8
From: North Texas
Yes folks have done it. Biggest tip to offer is to buy the 55918-08 $35.95 top clamp that comes stock on all the 08 and later fairing bikes. It is one piece and will give you the stability so it doesn't break where you drill it. Also put polyurethane riser bushings in while there.
Seasoned HDF Member
Joined: Jun 2006
Posts: 28,559
Likes: 3,954
From: Vermont
I had to drill my Khromewerks 300505's because of the TBW prior to them coming out with the 300515's for 08 and later. Here is a shot of the oval I made in the middle of the bottom of the bar. You can also see the top clamp that I mentioned.
Seasoned HDF Member
Joined: Jun 2006
Posts: 28,559
Likes: 3,954
From: Vermont
No, would be way too much involved.
Thread
Thread Starter
Forum
Replies
Last Post
ZeroFiveFour
Dyna Glide Models
9
Aug 26, 2008 10:27 AM
