I have a 2013 Dyna Switchack FLD

 

I had to reinstall the brace when I installed a PM Fast Air intake. Luckily I had saved the stock parts after installing the stage one intake. They were buried deep on my parts self..

 

Oops! It appears that the quite good Big Sucker installation video that was posted on YouTube is no longer available.

 

We run into this on occasion and the big sucker is designed to use that support plate. As stated above if you do not avhe it you need to fill teh gap where the support plate goes with washers or something as the kit is designed to put on a stock bike with the support plate. If you try putting this on without the plate it will not sit flush.

 

that plug is the intake air temperature harness and is supposed to be connected to your exhaust O2 sensor.

 

head over to the Dyna forums, and ask again

I have Touring Series wiring diagrams, not Dyna Series


I'm not sure about the previous post's suggestion

mike

 

Thanks guys much appreciated