Ohlins preload spanner + lock screw driver
Thread Starter
|
Outstanding HDF Member
Joined: Jan 2010
Posts: 2,916
Likes: 31
From: earth
Ohlins preload spanner + lock screw driver
Been running the Ohlins 3-3 for a while now and I stumbled onto what I think is decent tip. When making preload adjustments I couldn't find my usual small screwdriver to loosen the the plastic lock screw, so I grabed my cheap Kobalt 8 in 1 jewelers driver. I noticed that the insert bit shaft looked to be about the same diameter of the Ohlins spanner shaft. Out of curiosity I measured it with the calipers and it is exactly the same size. You can pop the driver bit out and use it as the spring preload spanner then put the bit back in and tighten the plastic lock screw. Its much smaller than the original Ohlins extra extra extra heavy duty spanner and it does both jobs, and the bits fit neatly inside the handle. They are only about 6 bucks so I bought an extra one and just leave it in my bag
http://www.lowes.com/ProductDisplay?...m&rel=nofollow
http://www.lowes.com/ProductDisplay?...m&rel=nofollow
Thread
Thread Starter
Forum
Replies
Last Post
