2001 flhtcui swingarm upgrade - questions
Thread Starter
|
Ultimate HDF Member
Joined: Aug 2010
Posts: 5,014
Likes: 739
From: Northern California
Northeastconfederate,
I have no desire to change the front pulley unnecessarily! I was trying to visualize how the pulley's would stay aligned? I assume the rear pulley with the narrower cog is shorter from the inside and the outside flange is in the same alignment as the 1 1/2" rear pulley?
Anyway, just glad it will work!
Thank you for your reply!
I have no desire to change the front pulley unnecessarily! I was trying to visualize how the pulley's would stay aligned? I assume the rear pulley with the narrower cog is shorter from the inside and the outside flange is in the same alignment as the 1 1/2" rear pulley?
Anyway, just glad it will work!
Thank you for your reply!
Club Member
Joined: Jun 2007
Posts: 45,429
Likes: 2,898
From: Bedford UK
The front pulley is much wider than the rear one. The rear narrow pulley is spaced a little further away from the wheel than the wide pulley, but the belt realigns itself. So as Eric above says, you will be fine!
Thread
Thread Starter
Forum
Replies
Last Post
DanDman
Frame/Suspension/Front End/Brakes
13
May 13, 2011 09:52 AM
