Fuel Moto pushrods
Road Master
Joined: Apr 2012
Posts: 1,096
Likes: 17
From: San Jose
You're going to like it.
Thread Starter
|
Road Master
Joined: Aug 2009
Posts: 946
Likes: 511
From: NH / VT border
Nice! I've already got a Fatcat with the wrapped perf baffle so it should run strong. How does it sound compared to stock? More lope? Throaty? Looking forward to the sound as much as the power...
Road Master
Joined: Apr 2012
Posts: 1,096
Likes: 17
From: San Jose
It has a nice lope, nothing like high compression and the 777's but it has a little lope.
I figured my sound change was more the header than the cam, but it is slightly louder at idle and rolling on the throttle. Cruising down the road it sounds the same.
I have 3 1/2" rinhardts.
I figured my sound change was more the header than the cam, but it is slightly louder at idle and rolling on the throttle. Cruising down the road it sounds the same.
I have 3 1/2" rinhardts.
Thread Starter
|
Road Master
Joined: Aug 2009
Posts: 946
Likes: 511
From: NH / VT border
Sounds good to me pal....love the sound of a cammed motor! Even after my install its gonna be parked until all this New Hampshire snow is gone. The cold weather doesn't bother me at all but all the sand and salt on the roads scares the crap out of me!
Road Warrior
Joined: Dec 2007
Posts: 1,498
Likes: 213
From: Atoka, TN
Just be sure to check them out before you start your project. I am quitting my install and the pushrods are all I have left. One of my intake pushrod's threaded piece is seized in the upper portion. I have been messing with it for the past hour so I can finish tonight. I will call Jamie tomorrow, but its not like he can get me a replacement pushrod before the weekend, so I am screwed by either not riding or having to go get a set of SE adjustables. It just sucks to spend $1200 and one of the parts is defective. I guess its just the way it is...
Thread
Thread Starter
Forum
Replies
Last Post
470004
General Harley Davidson Chat
2
Feb 25, 2019 06:08 PM
