Wiring question
Thread Starter
|
6th Gear
Joined: Aug 2011
Posts: 14
Likes: 0
From: Ont.Canada
Wiring question
Hi all, can some one tell me in the diagram what (DOM) and ( HDI) stand for,, I have highlighted with the arrows,,
Reason I am asking, my tri bar light has burnt out again, and I have an after market one to replace it. My bike is an 07 street glide, Canadian model so I know they are different when they come to the tri-bar light. My stock light was only a running light, and the dealer wants $130.00 just for the part
. The after market one I bought for $30.00 off of Amazon has, run/brake/and turn signals built in, but came with no instructions for the cost I'm not complaining So I am trying to figure out how to wire it in. Any one already done this? Any help would be great.
Below is the new tri-barn light connector,
Reason I am asking, my tri bar light has burnt out again, and I have an after market one to replace it. My bike is an 07 street glide, Canadian model so I know they are different when they come to the tri-bar light. My stock light was only a running light, and the dealer wants $130.00 just for the part
. The after market one I bought for $30.00 off of Amazon has, run/brake/and turn signals built in, but came with no instructions for the cost I'm not complaining So I am trying to figure out how to wire it in. Any one already done this? Any help would be great. 
Below is the new tri-barn light connector,
Cruiser
Joined: Oct 2013
Posts: 245
Likes: 2
From: NE NC
The black, red, and white wires go to the same connector that the old tribar light plugged in to. Should be on the left side under seat and run towards the back. The blue and the yellow I soldered to the purple I think) wires inside the tailight assembly that go to the corresponding turn signal. They should be identical plugs with two wires on each side of the tail light that go to the turns. Run the wires up the fender and inside the tail light then get to soldering.
I did this to a friend's 07 SG and his light has amber turns on each side with red in the middle for run/brake. He bought his on ebay and it was fairly inexpensive. Turned out real nice too.
I did this to a friend's 07 SG and his light has amber turns on each side with red in the middle for run/brake. He bought his on ebay and it was fairly inexpensive. Turned out real nice too.
Thread
Thread Starter
Forum
Replies
Last Post
