cut handle bar wires
Thread Starter
|
Stage I
Joined: Feb 2012
Posts: 1
Likes: 0
From: dover delaware
cut handle bar wires
cut handle bar wires and reconnected them back up and now the bikes lights come on and the full injection cycles threw but no lights will show up on the light bar on my new 2012 dyna street bob and when u press the start button nothing happens any advise
Stellar HDF Member
Joined: Feb 2009
Posts: 2,936
Likes: 20
From: Driftless Area
Might save you a trip but, wires are normally color coded, white with a colored stripe down it and so on, look close, the colors can fade. could be any combination. Your best bet on these things is to go wire by wire one by one!!!
It's a learning curve. Welcome to the forum.
It's a learning curve. Welcome to the forum.
Cruiser
Joined: Jul 2011
Posts: 194
Likes: 0
From: reading pa
Welcome to the forum. Just cut my wires on my street bob to do some internal wiring on the new bars. Make sure to check all those wires again because there should be no problems if there all reconnected properly. Good luck
Welcome to the forum from a sunny Southern California.
Trending Topics
Elite HDF Member
Joined: Feb 2010
Posts: 3,566
Likes: 0
From: Glen Burnie, MD
Welcome aboard from Maryland
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Verdad Gallardo
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
Verdad Gallardo
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Verdad Gallardo
10 Motorcycles You Should Never Buy
Joe Kucinski
