Turn Signal Indicator Upgrade
Thread Starter
|
Banned
Joined: May 2005
Posts: 14,496
Likes: 156
From:
Turn Signal Indicator Upgrade
Submitted by: Tommy Meisel
Tom went to the local AutoZone and bought two red 12 volt LEDs that plug into a 1/2 inch hole. He pulled the console, drilled two 1/2 holes in it, installed the new LEDs and then it was a simple matter to splice into the turn signal indicator wires just ahead of the plug that goes into the warning light console. It works like a charm, and only cost him $6.00.
Also see here for more ideas on building with LED's... HERE
Here's a photo of the final installation:
Tom went to the local AutoZone and bought two red 12 volt LEDs that plug into a 1/2 inch hole. He pulled the console, drilled two 1/2 holes in it, installed the new LEDs and then it was a simple matter to splice into the turn signal indicator wires just ahead of the plug that goes into the warning light console. It works like a charm, and only cost him $6.00.
Also see here for more ideas on building with LED's... HERE
Here's a photo of the final installation:
Thread
Thread Starter
Forum
Replies
Last Post
Tommy Meisel
Ignition/Tuner/ECM/Fuel Injection
9
Oct 29, 2007 12:01 PM
