'94 WG wire diagram
Thread Starter
|
Road Warrior
Joined: Apr 2007
Posts: 1,952
Likes: 15
From: Senoia, Ga., by way of Miami, Fl..
'94 WG wire diagram
Do you guys know where to find a good wiring diagram for my bike? These little lines all run together on an 8 1/2x11 piece of paper.. The HD manual sux for a diagram.. OK, I'm done complaining... I guess...
I got caught in a sprinkle on the way home yesterday and the pine pollen is insane here.. So, naturally, I decided to do a quick wash and dry. Since the wash, my lights dont work. Its happened before, but since I have rocker box gaskets leaking and the speedo cable broke(yea,its been a good week),I thought what better time to address it than today a nice sunny 70*F day... Oh well, now I have my tank on the bench and the "fuse" box loose so I can track the short down.. The "light" circuit breaker keeps tripping and I cant seem to fing the short. My next step is to swap the breaker with another one... Anyhow, thought I'd vent a bit before going back out there, maybe one of you guys has seen it before??
Thanks,
I got caught in a sprinkle on the way home yesterday and the pine pollen is insane here.. So, naturally, I decided to do a quick wash and dry. Since the wash, my lights dont work. Its happened before, but since I have rocker box gaskets leaking and the speedo cable broke(yea,its been a good week),I thought what better time to address it than today a nice sunny 70*F day... Oh well, now I have my tank on the bench and the "fuse" box loose so I can track the short down.. The "light" circuit breaker keeps tripping and I cant seem to fing the short. My next step is to swap the breaker with another one... Anyhow, thought I'd vent a bit before going back out there, maybe one of you guys has seen it before??
Thanks,
HDF Community Team
Joined: Dec 2005
Posts: 5,375
Likes: 2,570
From: NC USA
RE: '94 WG wire diagram
Diagram won't be much help, actually, and another breaker would only be advisable after you've corrected the problem.
You've got a wire pinched somewhere, or a corroded connector (in the pull apart plastic block comnnectors) Unfortunately, sometimes you have to get your fingers and eyes on every inch of wire to find it.
Yea, I know you didn't want to hear that... but you already knew what you were facing. Maybe the neighbor has a cute daughter that would come over and be a cheerleader? I know, the Comedy Zone hasn't called in a while either.
Good luck on your deal, and don't give up till you find it, else you'll be like I was 3-4 times, side of the road - rain storm - wishing I'd be a bit more dilligent in the shed.
You've got a wire pinched somewhere, or a corroded connector (in the pull apart plastic block comnnectors) Unfortunately, sometimes you have to get your fingers and eyes on every inch of wire to find it.
Yea, I know you didn't want to hear that... but you already knew what you were facing. Maybe the neighbor has a cute daughter that would come over and be a cheerleader? I know, the Comedy Zone hasn't called in a while either.
Good luck on your deal, and don't give up till you find it, else you'll be like I was 3-4 times, side of the road - rain storm - wishing I'd be a bit more dilligent in the shed.
Thread Starter
|
Road Warrior
Joined: Apr 2007
Posts: 1,952
Likes: 15
From: Senoia, Ga., by way of Miami, Fl..
RE: '94 WG wire diagram
OK, I knew if I vented a bit, it would help.... Anyhow, the diagram would have been a great help. They would tell me where the connectors are(if I was missing any).. I'm used to Ford diagrams, may they are awesome compared to this trash that HD puts out in the manual.. So, I was going to swap the relay for another one to see if it was tripping too easily.. I decided to use my Ampmeter instead and found it was a 60A draw
, figured that would make it easy.. I unplugged all the lights and modules, then started with the "wiggle test" on the harness.. Finally found the L/F turn signal wire was rubbing on the tree.. . Long story short, its fixed, with the tank and seat off it. Guess now I need to start the rocker boxes...
Thanks for the support and sounding board..
, figured that would make it easy.. I unplugged all the lights and modules, then started with the "wiggle test" on the harness.. Finally found the L/F turn signal wire was rubbing on the tree.. . Long story short, its fixed, with the tank and seat off it. Guess now I need to start the rocker boxes...Thanks for the support and sounding board..
Thread
Thread Starter
Forum
Replies
Last Post
