LED Tail Light Plug and Play?
Thread Starter
|
Road Captain
Joined: Sep 2011
Posts: 618
Likes: 3
From: Maryland
LED Tail Light Plug and Play?
I received the the Harley LED tail light for Christmas and was just looking over the instructions. No mention of how it reacts to CANBUS. I wanted to go ahead and get this installed and make sure it works ok ASAP, so my question is do I just disconnect the battery and install, or is there some other sequence involved? My service manual is on order, but I'm not even sure it would make mention of this anyway. Any help would be appreciated.
Grand HDF Member
Joined: Oct 2009
Posts: 3,824
Likes: 603
From: Myrtle Beach SC
Put several of them in, never disconnected the battery. Never had an issue. There's no power to that light until the switch is on. According to the service manual they have you do that for about anything I think. Easy plug and play, DIY thing. The LED light comes with a pig tail you need to plug into you system that combines some wiring. Follow the directions, it's a piece of cake
Road Master
Joined: Jun 2014
Posts: 1,219
Likes: 63
From: westland Michigan
I got the cd led for mine and couldn't screw them into the sockets with my bare hands. They come with a screw driver slot in the part that goes into the socket. Easy peazy after that. Run the 4 ways for a few minutes to set the canbus and your ready to ride again.
Batman .
Batman .
Thread
Thread Starter
Forum
Replies
Last Post
DugzKine
Want To Buy Motorcycles/Parts/Accessories
0
Nov 5, 2016 09:30 PM
