12in ape bars
Thread Starter
|
Stage III
Joined: Sep 2019
Posts: 3
Likes: 0
From: Minnesota
12in ape bars
Thinking of putting !2 in ape bars on the 2019 low rider, my question is there a kit for the cables and wiring as I really dont want dealer to do it as they want to charge me 900.00 bucks, if there is a DIY wire/cable kid it centrally would make for a more simple job.
any suggestions I would be thankful for.
Phil
any suggestions I would be thankful for.
Phil
Road Master
Joined: Aug 2007
Posts: 822
Likes: 261
From:
I got my wires from Guerrilla Cables, they make good stuff and have a few lengths. I got the 6" wire extensions from them. For the cables HD has them in increments, I did not change either since my bars are very narrow and I went a little shorter than you plan. Anyway, as I was thinking of going taller before my set up now I looked into the cables as well. On the Low Rider the stock cables are 24" brake and around 35" for the clutch. So, for +2 brake is part number 41800678 and clutch is #37200326. For +4 brake is #41800657 and clutch is 37200380. I went 8" riser and 2.5" bar, clutch works fine and brake is a tad bit tight so I may go +2 on that but my bars are only 28" wide. I think you could go +2 on the clutch and +4 on the brake but do some looking into the measurements of your bars before you take my opinion. God luck.
Thread
Thread Starter
Forum
Replies
Last Post
BikerJack69
General Harley Davidson Chat
11
Dec 31, 2011 11:34 AM
