Custom Cycle Engineering Motor Mount
Yea I'll double check my neck bearings I suppose since I didnt replace them but I have fully rebuilt the front end, regreased the bearings, checked and double checked fall away. Have still had the issue before and after. Still curious on any input with these rear mounts tho.
Seasoned HDF Member
Joined: Dec 2005
Posts: 19,899
Likes: 8,006
From: poway
Ive had both front and rear sputhes on my bike. Not saying they are bad or just my experience but I ended up taking the front off for the vibra technics front motor mount while still running the rear sputhe still get crazy wobbles and the bike seems super darty (can barely flick the bars at 60+mph and it could go into an easy tank slapper). After putting on that new front mount and added a CCE fork brace the bike has seemed much better for a while but it is making a come back. Possibly my rear mount is just shot now and a new one would make it better...but with most stuff if I replace it, I usually upgrade it.
just a note too bike has 28,500 on it now. bought it at 8k with the sputhes already on it. Reading about the stock mounts, I'd bet the rear is toast anyways
just a note too bike has 28,500 on it now. bought it at 8k with the sputhes already on it. Reading about the stock mounts, I'd bet the rear is toast anyways
Thread
Thread Starter
Forum
Replies
Last Post
