hickup
Thread Starter
|
Advanced
Joined: Mar 2016
Posts: 67
Likes: 46
From: Jacksonville, Oregon
hickup
It's near 60 deg. here today so I took the Fat Bob out for a little spin. I was only a couple of miles into my ride, cruising about 55 mph when the bike cut out for just a split second. A quick glance down and the speedo was swinging back up to my road speed so it must have dropped to near zero. I continued my ride with no further issues. I rode about 35 miles hitting speeds up to 80 mph and the bike seemed to run fine. Upon reaching home I ran the diagnostics and found codes P0131 & P0151 (frt & rear O2 sensors low) and the codes b1006 & b1007 but I can't seem to find what those mean. Anybody know? Thanks.
Road Warrior
Joined: Mar 2013
Posts: 1,397
Likes: 106
From: -)
years ago I had the same codes:
B1006 Accessory Line Overvoltage Instruments
B1007 Ignition Line Overvoltage Instruments
Checked and cleaned all my grounds at the battery and engine/frame. They were slightly loose and oxidized. Cleared the codes and they didn't come back (was told I was lucky that it didn't take out the stator and or the voltage regulator?)
B1006 Accessory Line Overvoltage Instruments
B1007 Ignition Line Overvoltage Instruments
Checked and cleaned all my grounds at the battery and engine/frame. They were slightly loose and oxidized. Cleared the codes and they didn't come back (was told I was lucky that it didn't take out the stator and or the voltage regulator?)
Thread
Thread Starter
Forum
Replies
Last Post
