Quick question for those using the Sears Yellow Jack when lifting their Dynas:

I purchased the Sears Yelow Jack and the Dyna frame adapters from the dealership. There are only 3 large red adapters in the kit, whick means that the bike will be supported by the three adapters and the fin welded to the frame rail.

My question is: Will the fin not bend when the bike is lifted and rests on the fin?

There is a fourth small black support in the kit, but the Sears Jack lift pads are not wide
enough to utilize the black pad (besides it's too small to make a difference).

Thank You!

 

black pad goes on the fin

 

The instructions say to use the black piece under the fin.

Will the yellow jack fit under a 2000 low rider? The red will not.

 

black pad goes under the fin my main man

 

The Yellow Jack fits under a 2008 Lowrider with no issues, but the Yellow Jack is much lower than the Red Jack.

 

YES, it will

 

heres a yellow sears jack an 06 dyna...and no adapters...no block of wood...just a bike and a jack...put kick stand up.....LO.........

[IMG]local://upfiles/19303/16ECC5F5435F433E86CFBD48975F3DBC.jpg[/IMG]

 

Lo -
without the pads or blocks - doesn't the bike get lifted by the oil pan and not the frame??