PC3 USB 2007 HD Dyna
Thread Starter
|
2nd Gear
Joined: Oct 2007
Posts: 6
Likes: 0
From:
PC3 USB 2007 HD Dyna
I recently installed VH Big Radius, SE Air Filter and the PC3 USB mods. I kept getting a staggered acceleratation and little torque. I called the manufactuer and found that there is an updated firmware release 2.2.2. that fixes this issue. Needless to say I applied the firmware and man does my Dyna perform. Just wanted to save any others some time.
Outstanding HDF Member
Joined: Dec 2006
Posts: 2,027
Likes: 4
From: Eastern NE
RE: PC3 USB 2007 HD Dyna
When I installed mine this summer, it had an off idle stumble. With the help of a member of this forum, I found out there was an upgrade to cover this also. Jamie at FuelMoto sent it to me and all was well.
Outstanding HDF Member
Joined: Jul 2007
Posts: 3,299
Likes: 2
From: By the "Betty water and the Wire"
RE: PC3 USB 2007 HD Dyna
Thanks for the link. Looks like they added some more MAP's for my Dyna. But still no ne for Rush slip-ons[:@]It's a conspiracy, I tell ya
Outstanding HDF Member
Joined: Dec 2006
Posts: 2,027
Likes: 4
From: Eastern NE
RE: PC3 USB 2007 HD Dyna
I think they figure all slip-ons have the same map. I had them install the map for my BS stage 1 and Cycle Shack slip-ons. Runs fine. Now changing from CS's to rinehart slip-ons and check withJamie on need for diff. map.He said the bike should run fine with the current map and if I have any trouble, to call him for another map.
Thread
Thread Starter
Forum
Replies
Last Post
xbox
Ignition/Tuner/ECM/Fuel Injection
2
Jul 7, 2009 08:17 PM
splitting_lanes
Ignition/Tuner/ECM/Fuel Injection
2
Aug 25, 2008 05:07 PM
