Loner Industries
Its not that had just take your time. There is a good thread on taking the plug under your tank apart and then running the wires. This will save you a lot of time over cutting and splicing. Personally I used weed eater line to fish through the bar. Then I attached the wire to it and carefully pulled the wire though. Also note on the gimps there is a small hole at the bottom bend. I worked each wire from the control through the small hole and then to the hole in the center of the bar. I would suggest doing this two step process one wire at a time.


where is this thread? do u have a link
thanks

 

Here is is, it is a good one to book mark.

https://www.hdforums.com/m_1328001/tm.htm

 

Those bars are wicked sick Loner. Almost wish I had seen them before I did my apes, but my speedo would have looked pretty stupid up there.

 

Thanks, that bike was fun to ride, tall narrow bars. I bassically took the sock night trian drag bar with and pull back and made a set of Z bars + 2.5 height. Then I made those risers 10", I got a little twist out of them but only if you tryed to. one of the best things was the two punisher shulls on the riser caps staring back at me, you can kind of see it in this pic.