Tail Lamp
Thread Starter
|
Cruiser
Joined: Jul 2007
Posts: 203
Likes: 1
From: Empire State
Tail Lamp
My tail lamp quit working on a ride. Checked fuse pannel , all connections in the base and the rear brake switch. Got it to come on but the brake light is activated. Nothing in the service manual on this and I noticed the rear brake pads are ready for replacement. Any input would be appreciated.
Thread Starter
|
Cruiser
Joined: Jul 2007
Posts: 203
Likes: 1
From: Empire State
First thing I did. I was surprised when I opened it up. Not the same as my last HD. Got it to light up took it home and messed with it the next day. Did a search on the forum and found a lot of info. There must of been a loose connection somewhere. No damaged wires under fender,front brake switch OK, messed with the connections on the rear switch. works now. Thanks for the reply
Road Master
Joined: Nov 2007
Posts: 1,223
Likes: 3
From: Peoria, AZ
Sure it wasn't ON and not "quit working"? Can't find it anywhere but seems like I had a Service Bulleting re: front brake switch staying engaged and keeping taillight on on certain Dyna years (I think '06 but not 100%).
Thread Starter
|
Cruiser
Joined: Jul 2007
Posts: 203
Likes: 1
From: Empire State
Tail lamp
It's a 07 Bob JRK Stock The only thing I can think of was the connections on the rear brake may have been dirty. It works now. It sucked when I pulled the lense off It's not like my old bike
Thread
Thread Starter
Forum
Replies
Last Post
edfromptowne
Electrical/Lighting/Alarm
0
Nov 5, 2009 07:00 PM
