Front turn signal relocation

Reply Subscribe

Thread Tools

Search this Thread

Apr 4, 2009 | 12:41 PM

painguy

Thread Starter

Advanced

Joined: Jul 2008

Posts: 57

Likes: 0

Front turn signal relocation

I installed the harley kit but it sticks out way too far for me. I know a lot has been on here about this but does anybody have any suggestions for a mount for a 2008 low rider that will be close to the forks? Thanks

Apr 4, 2009 | 12:54 PM

LeavenworthJeff

Cruiser

Joined: Dec 2005

Posts: 138

Likes: 0

I just did a front turn signal relocation with Drag Specialities part 2020-0347. This same kit can be found in the JP Cycle book also. If you do a search on this forum lots of write ups on this subject. I didn't get the HD one due to it sticking out so bad. I almost did the same thing but quite a few people had mentioned this issue on here. Of coarse to each his own as well.

LeavenworthJeff
05 FXDI

Apr 4, 2009 | 02:49 PM

lowridernj

Intermediate

Joined: Feb 2009

Posts: 26

Likes: 0

From: New Jersey

have a 2008 lowrider and used these mounts from Rivco part #FXD104-49, worked great.

Attached Thumbnails

Apr 4, 2009 | 02:59 PM

JRK5892

Banned

Joined: Mar 2007

Posts: 19,481

Likes: 25

From: Chicago suburbs (Elgin/Schaumburg)

i rock this... they are under my headlight, right above the fog lights... SUPER bright!

looks clean!

same thing on my brothers old sporty

Apr 4, 2009 | 07:45 PM

OldMike

Seasoned HDF Member

Joined: Feb 2009

Posts: 5,642

Likes: 1,985

From: Cleveland Zoo

Dennis Kirk has the nicest ones I've found, much closer than stock for 39/49mm forks, PT#21-2839
(Mfg by Drag Specialties PT# 2020-0347)
http://www.denniskirk.com/jsp/produc...=&skuId=212839

Attached Thumbnails

Front turn signal relocation-flange-009c.jpg

Last edited by OldMike; Apr 4, 2009 at 07:51 PM. Reason: added PT#

Apr 4, 2009 | 08:01 PM

fixxr

Road Captain

Joined: Oct 2008

Posts: 738

Likes: 1

From: Pa.

Got mine from Kury "two piece fork mounts" They make them for 39mm,41mm&49mm tubes.You use your lights and they WILL be close to the tubes! P.S.$$$$

Apr 4, 2009 | 08:09 PM

speedjunkie

Road Captain

Joined: Jul 2007

Posts: 682

Likes: 1

From: Wichita, KS

I just got the ones from Rivco last week too. Priced right at $35 right now. Look good too! I had previously made a set that went into the lower pinch bolt. Looked good and clean, but too much of a hassle to take the signals off when the forks need to come off.

Mike