Getting 06 Dyna tuned
Ultimate HDF Member
Joined: Oct 2007
Posts: 7,562
Likes: 11
From: Palm Harbor fl.
I don't have the dyno sheet as my brother stopped by the shop and checked on my bike. I will be picking up the bike tomorrow, but i do have numbers for you guys.
Starting out with the new air cleaner and pipe I had
67.1 Horsepower and 72.9 Torque
after tuning the set up i've got
78.5 Horsepower and 80.5 Torque.
Total gains of 11.4 horse and 7.6 torque for the tune. I figure i gained more than that over the stock set up. These numbers are most likely STD rating and would be less with SAE. I'm just focussing on the difference from beginning to end. Should be pretty happy!
Starting out with the new air cleaner and pipe I had
67.1 Horsepower and 72.9 Torque
after tuning the set up i've got
78.5 Horsepower and 80.5 Torque.
Total gains of 11.4 horse and 7.6 torque for the tune. I figure i gained more than that over the stock set up. These numbers are most likely STD rating and would be less with SAE. I'm just focussing on the difference from beginning to end. Should be pretty happy!
Supporter
Joined: Jan 2007
Posts: 15,788
Likes: 5,625
From: along the shore of Mishigami
Hey dlstanf2, With no intent on hijacking this thread but said your SE plugs were too cold for your stock engine? By the way the SE plugs ( I heard) have been pulled from inventory due to a plug coming apart in a 110" engine. What plugs did you install?
Thread Starter
|
Cruiser
Joined: Sep 2007
Posts: 204
Likes: 0
From: Santa Clara, CA
Picked up the bike and rode it to work today. Power is much improved from before and very smooth. I pulled from 70 to 80 on the freeway in top gear much easier than before.
James
James
Thread
Thread Starter
Forum
Replies
Last Post
ScrapingFloorBoards
Ignition/Tuner/ECM/Fuel Injection
4
Apr 28, 2019 07:04 PM
Z
Ignition/Tuner/ECM/Fuel Injection
48
Oct 2, 2018 04:01 AM
skywalker204
Ignition/Tuner/ECM/Fuel Injection
8
Sep 29, 2017 09:09 PM
