Layed her down!!
Thread Starter
|
Intermediate
Joined: Mar 2006
Posts: 33
Likes: 0
Layed her down!!
Well went to Myrtle beach Spring Rally. My wife and I pulled into the parking gargage I went one way she went the other. She found a better spot so I moved mine. Got over there and was sitting talking a bit and decided to lean over and park when low and behold I didn't put my side stand down. So there I was laying on the ground under my new 06 wide glide. The only thing that got scratched was my primary cover plate. What do I have to do to replace this? Is it just unscrewing the old one and putting on the new one, or is there a gasket or anything else to fool with?
Big Kahuna HDF Member
Joined: Feb 2006
Posts: 23,881
Likes: 34
From: USA
RE: Layed her down!!
It has a red oring rubber gasket that you can re-use if you are careful and retorque the screws back on in the pattern specified in the service manual. I got engine guards for mine because I know I'm gonna do that sooner or later. There are 2 kinds of people, those who have dropped their bike and those who are going to.
Elite HDF Member
Joined: Feb 2006
Posts: 3,818
Likes: 2
From: Twin Cities
RE: Layed her down!!
ORIGINAL: KBFXDLI
It has a red oring rubber gasket that you can re-use if you are careful and retorque the screws back on in the pattern specified in the service manual. I got engine guards for mine because I know I'm gonna do that sooner or later. There are 2 kinds of people, those who have dropped their bike and those who are going to.
It has a red oring rubber gasket that you can re-use if you are careful and retorque the screws back on in the pattern specified in the service manual. I got engine guards for mine because I know I'm gonna do that sooner or later. There are 2 kinds of people, those who have dropped their bike and those who are going to.
Thread
Thread Starter
Forum
Replies
Last Post
