Frame block dimensions
Thread Starter
|
Cruiser
Joined: Jun 2008
Posts: 221
Likes: 0
From: Nebraska
Frame block dimensions
I loaned out my frame blocks so a buddy could put his Dyna on a jack, and when he returned them, the small black one that doesn’t attach is missing. Can’t find it anywhere in his garage. Can anyone give me the height and width measurements so I can make up some sort of replacement? Thanks.
W
W
Club Member
Joined: Feb 2008
Posts: 11,483
Likes: 39
From: Passaic County, NJ
You could install the three other adapters and bring the lift up to the point of accepting some weight of the bike and get a measurement that way to keep the bike level.
But if that doesn't work for you, I can run up and measure the piece you are inquiring about shortly. I need smokes anyway.
But if that doesn't work for you, I can run up and measure the piece you are inquiring about shortly. I need smokes anyway.
Club Member
Joined: Feb 2008
Posts: 11,483
Likes: 39
From: Passaic County, NJ
Ok...here is what you requested:
4" long
3/4" high
1" deep
cut-out: 5/8" wide x 9/16" high
Personally...if you let your friend borrow a complete set of adapters and he can only return 3 out of 4 pieces, he should replace what he lost.
4" long
3/4" high
1" deep
cut-out: 5/8" wide x 9/16" high
Personally...if you let your friend borrow a complete set of adapters and he can only return 3 out of 4 pieces, he should replace what he lost.
Road Captain
Joined: Apr 2008
Posts: 577
Likes: 2
From: Brampton, Ontario, Canada
I agree, its only a few bucks, but its the principal.
on the other hand, its always 'a friend' that loses stuff. lol JK.
on the other hand, its always 'a friend' that loses stuff. lol JK.
Thread
Thread Starter
Forum
Replies
Last Post
