FXDWG docking hardware installation
Thread Starter
|
Tourer
Joined: Jan 2010
Posts: 254
Likes: 0
From: Arkansas
FXDWG docking hardware installation
Any advice from anyone who's installed the docking hardware for rear quick detach including the turn signal stalk change? Isn't there any way to avoid cutting the wires and having to splice under the fender?
Former Sponsor
Joined: Jan 2009
Posts: 19,364
Likes: 40
From: Los Angeles, CA
Take off the tail light lens and unplug the signals. Take the connector off the end and snake the wires out and back through. then reassemble.
Banned
Joined: Oct 2007
Posts: 1,579
Likes: 1
From: Ft. Hood, Texas
If you can get wires off the connector, I supposed you could, or maybe both pins won't fit thru hollow screw. i know in my case, I splice and the two wires barely made it thru screw, I had to lube them.
Also make sure you have all parts threaded thru wires, specially the tiny plastic cap closer to sigs. Have to pry bullets insides to reroute wires, somebody here designed a wire hook for this.
Also make sure you have all parts threaded thru wires, specially the tiny plastic cap closer to sigs. Have to pry bullets insides to reroute wires, somebody here designed a wire hook for this.
Last edited by HDDyna2006; Apr 27, 2010 at 09:35 PM.
Thread Starter
|
Tourer
Joined: Jan 2010
Posts: 254
Likes: 0
From: Arkansas
A million thanks.
Thread
Thread Starter
Forum
Replies
Last Post
W.P.
Dyna Glide Models
8
Apr 17, 2017 12:51 PM
DesertDyna
Ignition/Tuner/ECM/Fuel Injection
1
Jun 28, 2010 07:32 PM
