Burly 12" kit - wiring issue
Thread Starter
|
Stage IV
Joined: Dec 2010
Posts: 4
Likes: 0
Burly 12" kit - wiring issue
I need suggestions. I have all of the wires for the controls and signal run internally through the bars and I am mounting the controls etc on the bars. How do I route the wires for the signals up at the controls?
Road Master
Joined: Oct 2011
Posts: 827
Likes: 1
From: NJ
Oh ok, yours will most likely be different than my setup. My signals were wired into the switch housing along with the control wiring. It was one simple connector at the end of the wiring. I ended up relocating the signals and cutting the signal wires completely out I'd the switch housings.
Thread
Thread Starter
Forum
Replies
Last Post
Rollcage
General Harley Davidson Chat
11
Jun 29, 2016 11:55 AM
ebeattie
Dyna Glide Models
5
Dec 4, 2012 09:05 AM
