Another Handlebar Internal Wiring Question
Thread Starter
|
Stage IV
Joined: Feb 2007
Posts: 4
Likes: 0
From: Central Arkansas
Another Handlebar Internal Wiring Question
I have some wild1 wo504's I'm going to install on my 2006 fatboy. \\;\\\\\\; The internal wiring of the hand controls seems pretty straight forward, but I'm a little unsure of the best way to get the turn signal wires inside the bars. \\;\\\\\\; Do I need to drill holes in the bottom of the hand controls housing \\;to get the wires inside?
 \\;\\\\\\;
Any ideas or sugestions would be appreciated.
 \\;\\\\\\;
Any ideas or sugestions would be appreciated.
Tourer
Joined: Oct 2007
Posts: 292
Likes: 0
RE: Another Handlebar Internal Wiring Question
No you should beable to stuff them in the hole provided for the other wires. \\; It is a tight fit and I found the best way to do it is tape all the wires to a coat hanger and push it through. good luck
Thread Starter
|
Stage IV
Joined: Feb 2007
Posts: 4
Likes: 0
From: Central Arkansas
RE: Another Handlebar Internal Wiring Question
Hey appreciate the tip using the coat hanger. \\;\\\\\\; I thnk the wires will fit just fine in the hole in the handlebars but the hole in the handlebars is covered up by the controls housing. \\;\\\\\\;How is the best way to get the wires from the turn signals (which are on the outside of the housing) inside the housing so I can put them inside the handlebars? \\;\\\\\\; The stock handlebars were dimpled on the underside and would allow enough room to run the wires underneath. \\;\\\\\\; The wo504 bars are not dimpled.
Thread
Thread Starter
Forum
Replies
Last Post
