Frick!!! Steering Race Installed Backwards
Thread Starter
|
Intermediate
Joined: Apr 2009
Posts: 37
Likes: 0
Frick!!! Steering Race Installed Backwards
Can anyone advise me as to how to remove bearing races from the steering head that were installed backwards? I have Jims Steering Race Removal Tool but it will not work to remove improperly installed races...
Last edited by Ciphex; Jun 5, 2013 at 07:16 PM.
Outstanding HDF Member
Joined: Apr 2012
Posts: 2,938
Likes: 30
From: North Florida
Weld a rod to it and beat the rod out while it is still hot
Thread Starter
|
Intermediate
Joined: Apr 2009
Posts: 37
Likes: 0
Not a bad idea but I have neither the equipment nor proficiency to do so... I'm thinking about using a small grinding wheel on the end of a dremel and slowly going at the race until I can wedge it out.
I have a hard time imagining a tool to remedy this and I think I need to forcibly remove it.
I have a hard time imagining a tool to remedy this and I think I need to forcibly remove it.
Thread
Thread Starter
Forum
Replies
Last Post
Merv
Primary/Transmission/Driveline/Clutch
2
Jan 5, 2010 06:02 PM
