Bassani question
Thread Starter
|
Cruiser
Joined: Nov 2012
Posts: 208
Likes: 3
From: ohio
Bassani question
I just recently switched from rinehart crossbacks to bassani road rage 2 into 1. After installation I now have this weird vibration sound I can't track down. It's only at certain rpms. The only thing else I could think of is I ran the se flat gaskets. I was thinking about trying the tapered gasket but after googling I found some people use flat and others use tapered. It's not a heat shield sound either. Any advice? Thanks.
Elite HDF Member
Joined: Sep 2012
Posts: 3,791
Likes: 57
From: N Texas
All I can say is Kurt at Bassani told me to run the SE flat too but my dyno tuner whom I have a lot of respect for told me the tapered seals better. Might give the tapered a go and see if the sound goes away. Keep checking those heat shield though because I had a little noise from them that I had to chase down.
Cruiser
Joined: Jan 2012
Posts: 162
Likes: 0
From: Ontario
I have the road rage 2-1 on my FLHX and I noticed the other day while cruising at 2700-2950 RPM I had a weird vibration noise. It ended up being my screamin eagle ventilator A/C. I guess I did not torque down the bolts enough- I applied loctite this time too.
It's an awesome exhaust, congrats!
It's an awesome exhaust, congrats!
Intermediate
Joined: Nov 2008
Posts: 47
Likes: 0
From: Lees Summit Mo.
5109, about 2 years ago I put on a set of Bassani RR and had this vibration sound coming from the end cone of the exhaust. what I did was to put a 1/4 inch cable clip on the vertical back pressure rod in the exhaust. It changed the exhaust flow and fixed the problem
Thread
Thread Starter
Forum
Replies
Last Post
