Please help
Thread Starter
|
Advanced
Joined: May 2015
Posts: 93
Likes: 1
From: Michigan
Please help
Ok this past Sunday I washed my ultra limited 2014 like I normally do always. As I waxed and polished my bike I kept the radio on and ran my battery down. Normally I only wax for two hours but this time it was 3 or 4. So the next day of course it wouldn't start so I used my boost starter to start it. She fired right up however now I don't have auxiliary lights and my heated grips don't work. So I checked my fuse box and sure enough my 20amp auxiliary fuse was blown so I changed it out and now every time I start my bike it blows again.
Thread Starter
|
Advanced
Joined: May 2015
Posts: 93
Likes: 1
From: Michigan
I tried that and I tried drying off everything. It all worked after my wash. I'm thinking that I have a wire that's shorting out and blowing the fuse when I start it however I don't know where to begin to look for the short
Road Warrior
Joined: Jul 2012
Posts: 1,566
Likes: 55
From: Londonderry, NH
Do the heated grips have an on/off switch? if yes, then that's a good place to start looking.
Thread Starter
|
Advanced
Joined: May 2015
Posts: 93
Likes: 1
From: Michigan
No the heated grips don't have a switch just a **** on the end. When I turn the power on my bike I hear a pop sound down on the right hand side near my floor board and that's when the fuse burns out. I don't even have to start the bike and it blows
Thread
Thread Starter
Forum
Replies
Last Post
tmac00333
General Topics/Tech Tips
2
Oct 10, 2011 06:39 AM
