Security system questions

Reply Subscribe

Thread Tools

Search this Thread

Jul 19, 2018 | 06:44 PM

Larry the Landlord

Thread Starter

Road Captain

Joined: Jul 2009

Posts: 540

Likes: 36

From: Tulsa Ok

Security system questions

I have a Thunder Mountain Custom, it’s mostly harley parts. It came with the Harley security fob, but it does nothing, I’ve left it at home and the bike still starts. Now I have a security light on. Any ideas?

Jul 19, 2018 | 07:22 PM

mmesa005

Ultimate HDF Member

Joined: Aug 2010

Posts: 5,014

Likes: 739

From: Northern California

I believe it iindicates a burnt out turn signal bulb or stored DTC code?

Jul 19, 2018 | 09:02 PM

Larry the Landlord

Thread Starter

Road Captain

Joined: Jul 2009

Posts: 540

Likes: 36

From: Tulsa Ok

You may be onto something. I just installed LED turns and didn’t install the load equalizer.

Jul 21, 2018 | 04:38 AM

grbrown

Club Member

Joined: Jun 2007

Posts: 45,429

Likes: 2,898

From: Bedford UK

If it is easy to do so, swap back to the original bulbs and see if the code goes away. On the other hand your bike obviously has some sort of diagnostics, does it have canbus? If so it may not need an equalizer, just a magic tweek of the system, to adjust to your LEDs.

Jul 21, 2018 | 08:50 AM

Vernal

Club Member

Joined: Apr 2013

Posts: 7,682

Likes: 8,414

From: Utah

We put LED turn signals on the front of our bikes and CD had a reset procedure but I don't remember what it was. This was on their site.
From Custom Dynamics:
https://www.customdynamics.com/media...TSSM_Reset.pdf

Last edited by Vernal; Jul 21, 2018 at 08:53 AM.

Jul 23, 2018 | 09:50 AM

Zanthamos

Outstanding HDF Member

Joined: Feb 2015

Posts: 2,414

Likes: 433

From: Arkansas

Go into diagnostic mode (run switch to in and trip reset held while turning on the ignition switch) check for codes B1121 and B1122 those will be the turn signal codes.