Stock bottom end reliability
Road Master
Joined: May 2008
Posts: 1,196
Likes: 14
From: connecticut
Don't worry about it. If need to know check the runout.The only way Im taking a stock bottom end apart is to increase the stroke.
Elite HDF Member
Joined: Nov 2006
Posts: 3,647
Likes: 11
From: Stockbridge, GA (Atlanta)
09 RG 107 10.5 comp 575 cams 121/109 burnouts, wheelies, belt breaking, street racing, highway miles - non stop from Amarillo Tx to Atlanta GA -- no issues with the stock bottom end -- I have had to replace the rear rocker box gasket and head gasket -- they may have been from overheating. 44k miles
Thread Starter
|
Tourer
Joined: May 2011
Posts: 300
Likes: 6
From: South Carolina
With 15K my bottom end must be OK. I just need to find someone near by to do the work. I have a friend that had a local Harley dealer install his 107 kit. They talked him into using someone I've not heard of and they burned him on the labor. Anyway after I corrected the VEs the bike runs well with plenty of torque and it went to Sturgis and back. The dealer put the motor together well but can't tune and charge too much so I'm not going that way.
Billy
Billy
Thread
Thread Starter
Forum
Replies
Last Post
thewholehog
Exhaust System Topics
2
May 5, 2010 02:24 PM
