pushrod center.
Thread Starter
|
Road Master
Joined: Oct 2009
Posts: 1,131
Likes: 30
From: Las Vegas
pushrod center.
I have 2 sets of pushrods. Harley SE, and S&S quickies. The hollow of the pushrod on the SE is a bigger diameter than the S&S. Does that or will that make a difference? Has anyone ever experienced a pushrod hollow being blocked by debris of some kind?
Seasoned HDF Member
Joined: Jun 2017
Posts: 5,315
Likes: 4,272
From: Granville New York
I'd be happy to run either brand. Doubtful the small difference in the hole diameter is going to make a difference. I can't imagine anything big enough to clog a pushrod would make it through the lifters. Never heard of a pushrod getting clogged up...that would have to be some seriously dirty oil for a long time.
Grand HDF Member
Joined: Jun 2017
Posts: 4,620
Likes: 3,939
From: Near Yosemite
I just changed out my old tired S&S Lifters and Quickie Pushrods a few weeks ago and went with the SE Tapered Pushrods just for the bore diameter of the SE's. Went with Johnson Hylift Lifters just because they come hy-ly recommended...... this setup is a lot quieter then what I pulled out, but in all fairness, the S&S set up had 70k miles on them, sooooooo..........
Thread
Thread Starter
Forum
Replies
Last Post
Harley1004
Engine Mechanical Topics
15
Aug 18, 2022 11:17 PM
DK Custom - ST
Vendor For Sale Classifieds
6
Aug 9, 2022 10:25 AM
PeterV
Engine Mechanical Topics
12
Jul 10, 2018 10:15 PM
