I am collecting all the parts to convert my 1998 flhtcui from efi to carb. I have just about everything, but am hung up on a VOES. Should I just bite the bullet and get the on from the Moco? Are there any aftermarket alternatives? So far I've got a pingel fuel valve and tank adapters. S&S Super E kit, ultima ignition, and dynatek dc6-1 coil. I've mapped out my wiring and just need to get the VOES.

 

I got one on fleabay (OEM takeoff) that had the wiring and just plugged it in. Simple.

 

I checked that. The ones off ebay don't look like the ones in the micro fische. most are round, like a canister. The ones I found on ebay have 3 mounting holes and have a female connector for 3 wires.


http://www.ebay.com/itm/98-Harley-Da...41602e&vxp=mtr

 

Yep, mine is round........
The flat one you listed says it is from a FI bike. Don't know if there is a difference.

 

hmmmmm. On my efi bike, they call that at barometric pressure sensor (per my fsm). It mounts to the side of the ecm.

 

different -

you want one that kicks off at 5 1/2 inches of vacuum - if the one you get does not it is adjustable - can help you need a vacuum pump and an ohm meter and some silicone -- you want a round one w/ 2 wires any will do cheapest is usually a sporty

 

Thanks! I'll order one. I just got the tappet plug tool today, so hopefully I can get at least one of these bikes running in the near future.....