Advise on Ultima Ignition Install
Thread Starter
|
Cruiser
Joined: May 2011
Posts: 205
Likes: 1
From: Always moving
Ulitma ignition install went much better than expected. I soldered and heat shrank the tach and VOES wire and the other wires connected via round connectors (soldered on). Setting static timing was easy as pie as well. Thanks for all the info and suggestions guys.
Lt.
Lt.
Seasoned HDF Member
Joined: Aug 2008
Posts: 5,081
Likes: 2,159
From: Ohio
Set that rev limiter at 6400 and bounce it a few times to seat in the module 
Just kidding, congrats on the install
6400 rpm's and hitting the rev limiter when pulling away from a 103" does give ya an erection tho
Just kidding, congrats on the install
6400 rpm's and hitting the rev limiter when pulling away from a 103" does give ya an erection tho
Thread Starter
|
Cruiser
Joined: May 2011
Posts: 205
Likes: 1
From: Always moving
I set it to 5500... I dont know if Ill ever get brave enough to bring it higher
Thread Starter
|
Cruiser
Joined: May 2011
Posts: 205
Likes: 1
From: Always moving
The bike starts on first bump of the button even when cold... and this bike used to be a beast to start. I would have to pump the throttle twice, and hit the start button as I throttle up to push gas through the accelerator pump. I never choke it...ever.
Stage I
Joined: Jun 2017
Posts: 1
Likes: 0
From: Ontario Canada
Programming cable
plz let me no and how you made the cable
thank you cheers
Thread
Thread Starter
Forum
Replies
Last Post
