Installing exhaust, o2 sensor ???

Reply Subscribe

Thread Tools

Search this Thread

Jul 8, 2009 | 06:35 PM

ScReaMnEagLE22

Thread Starter

Road Master

Joined: Sep 2006

Posts: 764

Likes: 0

From: South Florida

Installing exhaust, o2 sensor ???

I'm going to be installing some V&H on my bike, but was wondering how install the o2 sensors without getting the wires all twisted ? Is there a a plug or connection somewhere near the sensor that I can just unplug it and then just reinstall after the sensor is tightened ?

Is it recommended to use Teflon or something similar when installing the o2 sensors ?

Jul 8, 2009 | 07:09 PM

comaman2

Banned

Joined: Mar 2008

Posts: 703

Likes: 1

i would install a power commader and eliminate the sensors .

Jul 8, 2009 | 07:20 PM

ScReaMnEagLE22

Thread Starter

Road Master

Joined: Sep 2006

Posts: 764

Likes: 0

From: South Florida

Not exactly an option at the time, but if you want to send me the $$ or the PC, I would be glad to run one. = ) thanks

Jul 8, 2009 | 07:31 PM

Arcane

Road Master

Joined: Jan 2007

Posts: 971

Likes: 2

From: Mid USA

The connector for the front o2 sensor is located in the front electrical caddy. The plastic caddy is between the frame down tubes and behind the regulator. The connector for the rear o2 sensor is located in the wiring harness (jumble of wires) under the seat.