Need DTC Code help
Thread Starter
|
Stage II
Joined: Jul 2008
Posts: 2
Likes: 0
Need DTC Code help
I have a 06 FLSTCI. \\;
It is throwing the following 3 codes:
P0113 IAT Sensor Voltage Open/High EFI
P0118 ET Sensor Voltage Open/High EFI
P0123 TP Sensor High EFI
Anyone have any ideas or suggestions?
I originally thought it was the voltage Regulator so I swapped that out, but that doesn't seem to have been it.
It is throwing the following 3 codes:
P0113 IAT Sensor Voltage Open/High EFI
P0118 ET Sensor Voltage Open/High EFI
P0123 TP Sensor High EFI
Anyone have any ideas or suggestions?
I originally thought it was the voltage Regulator so I swapped that out, but that doesn't seem to have been it.
Outstanding HDF Member
Joined: May 2007
Posts: 2,304
Likes: 31
From: Florida
RE: Need DTC Code help
It's telling you the resistance is high in the wire harnes to these three sensors .All these three sensors are in the same harness and they have been known to be stretched a little tight....I lift the tank and make the wires have a little slack to the sensor connections. \\; Tis ususally works 95% of the time.
Thread Starter
|
Stage II
Joined: Jul 2008
Posts: 2
Likes: 0
RE: Need DTC Code help
Slack in the harness doesn't seem to have helped. \\; I reset the codes and it's only throwwing p0113 and p0118 now.
 \\;
I think the throttle code might have been because I had to open the throttle to get it to start. \\; I cleared that one and it hasn't come back. \\;
The other two, the Air intake and the Engine temp are driving me crazy.
 \\;
I think the throttle code might have been because I had to open the throttle to get it to start. \\; I cleared that one and it hasn't come back. \\;
The other two, the Air intake and the Engine temp are driving me crazy.
Thread
Thread Starter
Forum
Replies
Last Post
Z
Ignition/Tuner/ECM/Fuel Injection
24
Nov 3, 2018 08:49 PM
leblanc1
Touring Models
46
Mar 20, 2013 05:38 PM
